PocketParameterData

This object is used to hold the settings for a pocketing toolpath and also the clearance tool section of a flat bottomed v carving toolpath.

Constructor

ProfileParameterData() - Constructor

Create a new object ready to have its parameters set

For Example:

local pocket_data = PocketParameterData()() 

Properties

.Allowance

R/W - double - allowance to leave on pocket sides when calculating toolpath

.AllowanceFormula

R/W - string -Formula for allowance to leave on pocket sides when calculating toolpath

.CutDepth

R/W - double -Final cutting depth below start depth

.CutDepthFormula

R/W - string -Formula for cutting depth below start depth

.CutDirection

R/W - integer - Cutting direction for toolpath. Valid values are ...

ProfileParameterData.CLIMB_DIRECTION

ProfileParameterData.CONVENTIONAL_DIRECTION

Note: Direction constants use ProfileParameterData. NOT PocketParameterData.

.DoRamping

R/W - bool - If true ramp entry to pockets (always zig-zag)

.DoRasterClearance

R/W - bool - if true doing raster area clearance, else offset

Returns: (bool) if true we will do peck drilling

.Name

R/W - string - The name for the toolpath

.ProfilePassType

R/W - integer - type of profile pass to perform . Valid values are ...

PocketParameterData.PROFILE_NONE

PocketParameterData.PROFILE_FIRST

PocketParameterData.PROFILE_LAST

.ProjectToolpath

R/W - bool - If true and used with Aspire, toolpath is projected onto model surface after calculation

.RampDistance

R/W - double - distance to ramp over if doing ramping

.RasterAllowance

R/W - double - allowance to leave on pocket edge between rasters

.RasterAngle

R/W - double - Angle in degrees to create raster toolpaths at

.StartDepth

R/W - double - Start depth for toolpath below material surface

.StartDepthFormula

R/W - string -Formula for start depth for toolpath below material surface

.UseAreaClearTool

R/W - bool - If true use a larger tool for area clearance

Example Code

-- Create object used to pass pocketing options - used for area clearance only
local pocket_data = PocketParameterData()
-- start depth for toolpath
pocket_data.StartDepth = start_depth
-- cut depth for toolpath this is depth below start depth
pocket_data.CutDepth = flat_depth
-- direction of cut for offet clearance - ProfileParameterData.CLIMB_DIRECTION
-- or ProfileParameterData.CONVENTIONAL_DIRECTION - NOTE: enum from ProfileParameterData
pocket_data.CutDirection = ProfileParameterData.CLIMB_DIRECTION
-- if true use raster clearance strategy , else use offset area clearance
pocket_data.DoRasterClearance = true
-- angle for raster if using raster clearance
pocket_data.RasterAngle = 0
-- type of profile pass to perform PocketParameterData.PROFILE_NONE ,
-- PocketParameterData.PROFILE_FIRST orPocketParameterData.PROFILE_LAST
pocket_data.ProfilePassType = PocketParameterData.PROFILE_LAST 

References

Please Note: The base material for the contents found in this WiKi was sourced from Vectric Lua Interface for Gadgets, version 2.05, published September 12, 2018. by Vectric Ltd. Most current document from Vertric can be downloaded at Vertric Developer Information